It's all about the answers!

Ask a question

How does one use IBM HTTP and WAS together so users nolonger have to type in port to access RTC?


Karl Athanasiou (3121217) | asked Aug 07 '12, 4:08 p.m.

Please excuse me if this has been answered before but with the vast amount of information here I am having a hard time finding this out.

Is there a way to utilize IBM HTTP server with WAS so that my EU's nolonger have to specify the port number when trying to access RTC?

example:

https://rtcccm.server.com = https://rtcserver.server.com:9443/ccm

I am new to this so if there is a decent set of documented steps I would be greatly appreciative.

Regards,

Karl

Accepted answer


permanent link
Daniel Toczala (88211414) | answered Aug 08 '12, 10:39 a.m.
FORUM MODERATOR / JAZZ DEVELOPER
Check out the article on Hiding port numbers from the public server URI.  That should make it all clear.
Karl Athanasiou selected this answer as the correct answer

Comments
Karl Athanasiou commented Aug 08 '12, 11:02 a.m.

Dan, Thank you sir.... Exactly what I was looking for. Are you heading to Reno In November?


Daniel Toczala commented Aug 08 '12, 11:06 a.m.
FORUM MODERATOR / JAZZ DEVELOPER

I MIGHT be there. If I am not there, I am sure that some of my Jumpstart team members will be there. Make sure to look for them.

One other answer



permanent link
sam detweiler (12.5k6186201) | answered Aug 07 '12, 10:39 p.m.
change the WAS config to be only port 443, then https defaults to 443..


Your answer


Register or to post your answer.