Setting the filter has created redundant numbers of data.
Hye,
I have some difficulties using the filter. I created a report using Studio Report in Rational Insight. I put all the project and task detail to be displayed in a dashboard. I filtered the specific project to get total number of task. After I ran the report all the details are displayed according to the filter but only the total number of task is wrong. It displayed all the data in the project and did not respond to the specific filter, indirectly it showing the repeated data in total number of task column. Can I get some advice here how to fix this.
Thank you.
Regards,
Shaff Raphael
One answer
Hello Shaff,
from the description, without seeing the report, it's a bit difficult to figure out the exact problem.
In general I would advise trying to play with the Aggregate Function and Rollup Aggregate Function properties.
You can set Aggregate Function to the type of aggregation you want to display (total, count, average, ...) and usually Rollup Aggregate Function to Automatic.
Best Regards,
Francesco Chiossi
from the description, without seeing the report, it's a bit difficult to figure out the exact problem.
In general I would advise trying to play with the Aggregate Function and Rollup Aggregate Function properties.
You can set Aggregate Function to the type of aggregation you want to display (total, count, average, ...) and usually Rollup Aggregate Function to Automatic.
Best Regards,
Francesco Chiossi