Builds and Components
5 answers
You can control this indirectly by customizing the flows in the workspace
editor. Open the workspace editor, select a flow target, and Edit it to
"Flow only components checked below"
There is a load rules setting in the build definition on the Jazz Source
Control page, but I don't know if it allows you to completely omit
components.
---
Ryan Manwiller
Jazz Team
editor. Open the workspace editor, select a flow target, and Edit it to
"Flow only components checked below"
There is a load rules setting in the build definition on the Jazz Source
Control page, but I don't know if it allows you to completely omit
components.
---
Ryan Manwiller
Jazz Team
OK thanks Ryan
Ryan Manwiller wrote:
Ryan Manwiller wrote:
You can control this indirectly by customizing the flows in the
workspace editor. Open the workspace editor, select a flow target, and
Edit it to "Flow only components checked below"
There is a load rules setting in the build definition on the Jazz Source
Control page, but I don't know if it allows you to completely omit
components.
---
Ryan Manwiller
Jazz Team
Just tried a "Personal Build" that pulls the source from my Workspace.
Here there's no stream involved so I have no way to limit the components
to be fetched during the build.
I wish that the Build Definition offered a means to select the
components to be fetched.
Should I raise an enhancement ?
Ryan Manwiller wrote:
Here there's no stream involved so I have no way to limit the components
to be fetched during the build.
I wish that the Build Definition offered a means to select the
components to be fetched.
Should I raise an enhancement ?
Ryan Manwiller wrote:
You can control this indirectly by customizing the flows in the
workspace editor. Open the workspace editor, select a flow target, and
Edit it to "Flow only components checked below"
There is a load rules setting in the build definition on the Jazz Source
Control page, but I don't know if it allows you to completely omit
components.
---
Ryan Manwiller
Jazz Team