It's all about the answers!

Ask a question

Can we have 'tabs' in DNG for opening multiple modules?


Shuchita Tripathi (31436193) | asked Oct 19 '16, 8:48 a.m.
Hi,

Can we open multiple modules in tabs in DNG?
This tabbed page layout is available in RQM, however i am not able to find it in DNG.

Version: 6.0.2

Thanks

Accepted answer


permanent link
Keith Collyer (456511) | answered Oct 19 '16, 4:40 p.m.
JAZZ DEVELOPER
Yes, you can, using the browser tab mechanism you can right click on a link to a module and say "open in new tab". Ctrl-click might also work, depending on your browser and how you have it set up. This is also available directly in DNG in a few places (can't remember where).
Note this is not like the tabs in RTC (don't use RQM that much), where each tab inside the browser tab displays different information about the artifact.
Shuchita Tripathi selected this answer as the correct answer

Comments
Shuchita Tripathi commented Oct 20 '16, 8:48 a.m.

 Hi Keith,

Thank you for your answer.
However, i am not looking for opening in new tab of browser.
RQM has in built tabs for opening multiple test artifacts within the application.
I am looking for something similar in DNG.


Keith Collyer commented Oct 20 '16, 9:34 a.m. | edited Oct 20 '16, 9:36 a.m.
JAZZ DEVELOPER

Then the answer is no, there is no mechanism within DNG to have multiple application tabs inside a single browser tab.
I thought that was implicit in my answer, but clearly not ;)

Your answer


Register or to post your answer.