Can the report resource "Manual Execution Status" be used in a report pulling multiple execution records?
I created a Test Report that uses the resource "Manual Execution Status" but it only allows for the selection ResultId at a time.
Is there a way to select multiple records using this report resource?
Also can this report be modified to bring back additional data (other than the default)?
Thanks!
Is there a way to select multiple records using this report resource?
Also can this report be modified to bring back additional data (other than the default)?
Thanks!
Accepted answer
Hi Jeff,
The report is used on the results view and it's designed to display the information of only one result at a time, that's why the parameter doesn't allow you to select more than one.
If you want the OOTB report to be modified (which will cause changes on the result view where it's displayed), you can send a Request For Enhancement specifying what additional data you would like to see there.
Thanks,
Clara
The report is used on the results view and it's designed to display the information of only one result at a time, that's why the parameter doesn't allow you to select more than one.
If you want the OOTB report to be modified (which will cause changes on the result view where it's displayed), you can send a Request For Enhancement specifying what additional data you would like to see there.
Thanks,
Clara
Comments
Jeffrey Burke
Nov 12 '14, 3:42 p.m.Correction, should have wrote:
" but it only allows for the selection of one ResultId at a time."
Clara Forero
JAZZ DEVELOPER Nov 14 '14, 5:32 p.m.Hi Jeffrey,
What did you use to create the Test Report? Is it a BIRT report, RRDI? Each tool has its own way of marking a parameter as single or multiple selection.
Clara
Jeffrey Burke
Nov 17 '14, 9:41 a.m.Hi Clara,
Thanks for the reply!
I used the default "Reports --> Create Report From Resource" option.
Jeff