Time out error when trying to compare DM configurations using Configuration Management
Hi,
I have some configurations/snapshots on our Design Management 4.0.6. I would like to display differences between some snapshots and try to use Configuration Management for this purpose. I check two certain snaphots in the 'Actions' column and press 'Compare' button. After a couple of seconds the following dialog window appears: 'Your compare session has timed out. Do you want to reload this session?'. If I press 'yes', I get the same window.
There are no error messages in the error log.
There is another interesting fact: when analysing via FireBug, it can be noticed, that the client receives a response with possibly relevant data, but some redirect appears then, and the previous data are lost. I have an intent to post specific link a bit later.
Thanks a lot for any possible ideas,
Regards,
Dmitry
I have some configurations/snapshots on our Design Management 4.0.6. I would like to display differences between some snapshots and try to use Configuration Management for this purpose. I check two certain snaphots in the 'Actions' column and press 'Compare' button. After a couple of seconds the following dialog window appears: 'Your compare session has timed out. Do you want to reload this session?'. If I press 'yes', I get the same window.
There are no error messages in the error log.
There is another interesting fact: when analysing via FireBug, it can be noticed, that the client receives a response with possibly relevant data, but some redirect appears then, and the previous data are lost. I have an intent to post specific link a bit later.
Thanks a lot for any possible ideas,
Regards,
Dmitry