Qs on "Plan Requirements Defect Impact"
Using 3.0.1...
a) When configuring this report, you are presented with a list of requirements. How does it decide which requirements to show you? (Note that you have not yet selected a plan before it shows you requirements)
I created a new requirement and cannot get it to show up in the list, even after running the DW jobs.
b) How do get I something to show up in this report? For one of the requirements that DID show, I navigated to the test case, ran it, failed the run and submitted a blocking defect (and set the link to blocker). Then I re-ran the DW jobs. Nothing new in report.
a) When configuring this report, you are presented with a list of requirements. How does it decide which requirements to show you? (Note that you have not yet selected a plan before it shows you requirements)
I created a new requirement and cannot get it to show up in the list, even after running the DW jobs.
b) How do get I something to show up in this report? For one of the requirements that DID show, I navigated to the test case, ran it, failed the run and submitted a blocking defect (and set the link to blocker). Then I re-ran the DW jobs. Nothing new in report.
One answer
Hi Jeffrey,
a. The Requirements in the parameter list are only those associated with a Test Case.
b. Is the defect you created associated with the Execution Result or with the TER directly. The report will only report defects associated with theExecution Result . There is a WI to fix this already 32339.
I hope that helps,
Mark
a. The Requirements in the parameter list are only those associated with a Test Case.
b. Is the defect you created associated with the Execution Result or with the TER directly. The report will only report defects associated with the
I hope that helps,
Mark