Is it possible to add letters to an ID? e.g. SR-2033489
Accepted answer
One other answer
Hi Zoe,
There is a page on Hazel Woodcocks blog illustrating the results of Bartosz's suggestion
It does not look very good in DNG but does look good when properly concatenated during RPE publishing
Hopefully we will get elegant in-tool concatenated presentation of this solution in the future.
Comments
One of the annoying limitations of this seemingly useful solution I have found is that it seems you cannot specify a default value for the attribute on a per-artifact basis.
It would be good if you could define a Prefix atttribute and then give it the default value 'SR-' when used on System Requirements and 'TR-' when used on Technical Requirements etc.
But you can only give the attribute itself a default value so for Prefix default values to work usefully it seems you need to create a separate attribute for each artifact type.
One of the annoying limitations of this seemingly useful solution I have found is that it seems you cannot specify a default value for the attribute on a per-artifact type basis.
It would be good if you could define a Prefix attribute and then give it the default value 'SR-' when used on System Requirements and 'TR-' when used on Technical Requirements etc.
But you can only give the attribute itself a default value so for Prefix default values to work usefully it seems you need to create a separate attribute for each artifact type.
Comments
Bartosz Chrabski
Mar 23 '21, 7:48 a.m.I assume that it is DNG related question