Getting specific baseline from DOORS/DNG using OSLC
In official CLM documentation it is claimed the support for OSLC Configuration Management working draft from OASIS.
However, the baselines or streams cannot be obtained from DNG 6.0.2. 1. How are the steps to configure and enable the Configuration Management (baselines or streams)? 2. Is it possible to receive CM baselines and stream from DNG 6.0.2 / DOORS 9.6? The documentation does not provide a definitive response about this issue.
However, the baselines or streams cannot be obtained from DNG 6.0.2. 1. How are the steps to configure and enable the Configuration Management (baselines or streams)? 2. Is it possible to receive CM baselines and stream from DNG 6.0.2 / DOORS 9.6? The documentation does not provide a definitive response about this issue.
Accepted answer
You need an activation key to enable CM at the application level, then you need to activate it for each project that's going to use CM. Here are instructions for obtaining and applying the key. If you haven't already, you should also read this article for background on enabling CM in CLM. It should address your question about baselines too.