It's all about the answers!

Ask a question

Unable to multiple selection of the sub teams to Acess Group


Don Yang (7.6k2196132) | asked Feb 19 '14, 7:26 p.m.
edited May 23 '16, 10:18 p.m. by David Lafreniere (4.8k7)
RTC4.0.3/4.0.5 tested.

if we want to add many sub-teams into an Access Group, we need to add each team
one by one. The tool does not allow to do multiple selection in one go:
e.g.
TeamA
-SubTeam1
-SubTeam2
-SubTeam3

We need to create the group, expand all project area, select the specific
PA , then locate the team.
-> if we have other team to add, have to start from expand all project
area again......

Does anyone know any easy way to do multiple selection? I could not find any existing RFE as well.

Accepted answer


permanent link
Ralph Schoon (61.5k33643) | answered Feb 20 '14, 5:49 a.m.
FORUM ADMINISTRATOR / FORUM MODERATOR / JAZZ DEVELOPER
Please consider creating an enhancement request to make this easier to use.
Don Yang selected this answer as the correct answer

Comments
Don Yang commented Feb 20 '14, 5:55 a.m.

Thank Ralph.
One purpose for this post is to check if we need to have a RFE for the behavior. So we don't have any other way to make the job easier. I would suggest the user to create a RFE or I would do it.

Your answer


Register or to post your answer.