command: lscm change-target component doesnot work ?

Kaushambi Singh (371●3●103●79) | asked Mar 18 '13, 3:29 p.m.
edited Mar 19 '13, 7:25 a.m.

Hi, on RTC CLI, When I run the command : lscm change-target component <workspace name> <Target Stream name> <Component name> , the command gives output as target changed but in actual it only adds the new stream in the flow target section. There is no <scoped> word mentioned. Also when I do lscm status I don't find the target stream changed for this component. Its the same default target stream. This is for RTC 3.0.1.3.

Comments

Kaushambi Singh commented Mar 19 '13, 5:47 a.m.

Please reply to this question .

Kaushambi Singh commented Mar 19 '13, 1:48 p.m.

Kindly reply to this question.

One answer

Most liked answers ↑|Newest answers|Oldest answers

permanent link

Tim Mok (6.6k●3●8) | answered Mar 25 '13, 2:24 p.m.
JAZZ DEVELOPER

It sounds like you've encountered 219636: Status subcommand does not show flow targets for non-default flow.

The regression may have occurred earlier than that. Can you open a defect about this? This fix might have to be backported to 3.0.1.6 if it is a regression.

It's all about the answers!

Related questions

command: lscm change-target component doesnot work ?

One answer

Your answer