It's all about the answers!

Ask a question

Execution Status by Test Case Category using Weight


Paula Izaurralde (6122628) | asked Sep 11 '12, 2:44 p.m.
The report is omitting failed test cases.
Does anyone know how can I do to configure the report to show all states?

Accepted answer


permanent link
Mark Victory (26635) | answered Sep 11 '12, 2:48 p.m.
JAZZ DEVELOPER
Hi Paula,

The report uses the result points rather than the overall result value.
Is it possible that the result of the overall execution of the TCER was set to Fail but none of the points were set to fail?
Paula Izaurralde selected this answer as the correct answer

3 other answers



permanent link
Paula Izaurralde (6122628) | answered Sep 11 '12, 2:55 p.m.
Yes!, you were right!
Why wasn't the weight automatically set failed?

permanent link
Mark Victory (26635) | answered Sep 11 '12, 3:00 p.m.
JAZZ DEVELOPER
Hi Paula,

I'm not sure why they points didn't default.
I think, at the least, you are typically prompted/warned when the result is saved that the overall result is fail but no points were marked failed.

permanent link
Paula Izaurralde (6122628) | answered Sep 11 '12, 3:06 p.m.
Thank you, I will make sure everyone is aware of it.
Thanks again

Your answer


Register or to post your answer.


Dashboards and work items are no longer publicly available, so some links may be invalid. We now provide similar information through other means. Learn more here.