It's all about the answers!

Ask a question

Is it possible to access few VOB from clear case and few components from RTC


Dhanesh Kumar Venu (111) | asked Feb 18 '13, 2:41 a.m.
edited Feb 19 '13, 5:56 p.m. by Susan Lafera (11)
My project source control management not fully migrated to RTC, it is in the middle of the process.
Still i need to deliver my work product which are developed in RTC and Clearcase separately.
Is there a mechanism when i load a config spec in Clear case that loads the source code from RTC also?
so that i can get the entire source code loaded for that specific project on a single shot.

One answer



permanent link
Geoffrey Clemm (30.0k23035) | answered Feb 18 '13, 10:06 a.m.
FORUM ADMINISTRATOR / FORUM MODERATOR / JAZZ DEVELOPER
The easiest way to load a single file area with code developed in ClearCase and with code developed in RTC-SCM would be to use the RTC ClearCase Synchronizer to synchronize the appropriate stream/branch in ClearCase with a corresponding stream in RTC-SCM.   You then have all the code in both ClearCase and RTC-SCM, and can use either a ClearCase view or an RTC-SCM workspace to view the combination.   You schedule the synchronizer to run each night, so that there is no manual intervention required.  
For details, see:
 https://pic.dhe.ibm.com/infocenter/clmhelp/v4r0m1/index.jsp?topic=%2Fcom.ibm.team.connector.scm.cc.doc%2Ftopics%2Fc_sync_intro.html

Your answer


Register or to post your answer.