It's all about the answers!

Ask a question

RQM 4.0.1 to Doors 9.4 Integration Slides


vinay kumar nukala (4236472) | asked Feb 12 '13, 4:48 a.m.
retagged Feb 14 '13, 9:15 a.m. by Douglas Bush (28125)
Hi,
     I have completed my integration up to:
1. Inbound
2.Outbound Friend function

and entered in to Doors 9.4
1. right click on database and selected  properties.

Up to here i have done...

Please help me or send me the slides for  RQM 4.0.1 to Doors 9.4 Integration

3 answers



permanent link
Douglas Bush (28125) | answered Feb 14 '13, 9:14 a.m.
FORUM MODERATOR / JAZZ DEVELOPER
Hi Vinay,
Did you see the online help for this integration here in the CLM 4.0.1 information center?
http://pic.dhe.ibm.com/infocenter/clmhelp/v4r0m1/topic/com.ibm.rational.test.qm.doc/topics/t_ovw_int_rqm_doors.html
See also this video on YouTube: http://www.youtube.com/watch?v=a43HDifxNQE
I hope these help.

Comments
vinay kumar nukala commented Feb 15 '13, 6:14 a.m.

Hi,

   I have watched the video but the video is giving information about after the integration what we can do. But i need the integration part how to integrate doors 9.4 to rqm 4.0.1 slides please help me.

And i also checked the first link it is giving error page not found.


permanent link
Douglas Bush (28125) | answered Feb 15 '13, 9:45 a.m.
FORUM MODERATOR / JAZZ DEVELOPER
Vinay, Please check the link again to the RQM/DOORS integration help. This help contains configuration instructions. This is a public information center and I can successfully connect to it now.
http://pic.dhe.ibm.com/infocenter/clmhelp/v4r0m1/topic/com.ibm.rational.test.qm.doc/topics/t_ovw_int_rqm_doors.html


permanent link
vinay kumar nukala (4236472) | answered Feb 16 '13, 6:57 a.m.
Thank you very much for your support ...I have followed the link and connected doors 9.4 to rqm 4.0.1 but i stuck up at the following area.
  1. In the Association list, select Uses-Requirements. This setting specifies that the project area can use artifacts from, and can create artifacts within, the target artifact container.



I cannot find the uses -Requirements in the association list. please hep me. what should i do now?

Your answer


Register or to post your answer.