It's all about the answers!

Ask a question

Can't create a link in DOORS


Raj Kapoor (2741925) | asked Sep 17 '12, 1:05 p.m.
retagged May 25 '13, 4:35 p.m. by Scott Rich (57136)
I could not link the requirements after classification and setting targets to RTC. I am getting an Link error. 

1. I worked on the X260-2016-Baseprog/06-Subsytem/PTS_100 Dressed Engine/Engine - Gasoline.
2. I classified the requirements, created 2 variants and set targets for a couple of requirements to see if I could link them. I saved the Targets view and closed the module. I clicked confirm when I was asked "Link Requirements to RTC". 
3. That is when I got the error saying "Create link failed"


4 answers



permanent link
Paul Strachan (512) | answered Sep 18 '12, 11:33 a.m.
Hi Raj

Issues with DOORS 9.3.0.6 should be raised with Customer Support. Here is a link to the Support Portal that will aid in this - http://www-947.ibm.com/support/entry/portal/Overview/Software/Rational/Rational_DOORS

Paul

permanent link
Marie Steele (40136) | answered Sep 17 '12, 5:52 p.m.
FORUM MODERATOR
Hi Raj
Can you confirm what version of DOORS and RTC you are using and what the build numbers are.

Thanks
Marie

permanent link
Raj Kapoor (2741925) | answered Sep 18 '12, 8:48 a.m.
 IBM Rational DOORS9.3.0.6 and RTC 3.0.1.1 Build number  not sure 

permanent link
Paul Strachan (512) | answered Sep 21 '12, 11:43 a.m.
DOORS 9 questions need to be raised as PMRs with Rational Customer Support. Here is a link to the DOORS area of the Support Portal to aid with that:
http://www-947.ibm.com/support/entry/portal/Overview/Software/Rational/Rational_DOORS

Your answer


Register or to post your answer.