DNG Workflow state link permissions

Harrison Vince (35●1●11) | asked Jun 13 '19, 10:13 p.m.

Are we able to control the creation/deletion of links via the workflow state? For example, when an artifact is in the 'complete' state, some link types should not be able to be created/deleted.

Even better would be to have control over link type direction. For example an incoming link is okay, but not an outgoing link.

We are using 6.0.6 iFix006.

Thanks.

Comments

Richard Watson commented Aug 03 '20, 5:34 a.m.

FORUM MODERATOR / JAZZ DEVELOPER

At this time it is possible to restrict who can manipulate links of defined types but not links from/to defined artifact types.

If you are in a position to switch on Configuration Management then you could govern the changes through Change Sets which would allow you to reject the change after the proposed change.

This functionality works the same way in 7.0.1.

I hope this helps

Be the first one to answer this question!

It's all about the answers!

Related questions

DNG Workflow state link permissions

Be the first one to answer this question!