Link is not showing on DNG

Monali Jambhulkar (84●16●38) | asked Jan 15 '18, 1:41 a.m.

Hello All,

We have added requirement in Test case in "Requirement link " section of the Test case in RQM . Its is visble in RQM .

But when i have open the same req in DNG , and see Link section,. I am not able to see any Test cases in Link section in DNG.

I am expecting if link is present in RQM side , then It should be visible in DNG side also.

Please suggest.

I am using DNG an RQM 6.0.3 ver.

Thanks

One answer

Most liked answers ↑|Newest answers|Oldest answers

permanent link

Elohim Arranaga (246●1) | answered Jan 16 '18, 8:51 a.m.
JAZZ DEVELOPER

Hi Monali, as you mention the link should be also reflected on DNG side, however if you are using a configuration management enabled project area the links may take a while to be reflected, the time depends on your refresh rate in ldx, normally from 1 to 5 mins but can be manually changed. Now if this is not the case or if you have given enough time and the link is still not appearing then this could be a product issue, please open up a ticket for support so we can follow up and investigate more thoroughly.

Comments

Monali Jambhulkar commented Jan 17 '18, 1:15 a.m.

Thanks alot.

But I am not using Configuration management enable project area.

Still link is not visible on DNG side.

This could be Product issue. I will open the ticket for the same.

Thanks

It's all about the answers!

Related questions

Link is not showing on DNG

One answer

Your answer