It's all about the answers!

Ask a question

Sandbox problems - cannot complete creation of projects

Bruno Di Giandomenico (50916) | asked Apr 19 '16, 7:49 a.m.
 Hello, I must have done something terribly wrong. I have deleted the project I had been using in my sandbox and have tried recreating another one to see if Config Management was activated. Unfortunately, until now, the creation of the project stops at 75%, and Creating Lifecycle Project never ends.After 3 hours I have deleted the web page, even though there was a warning not to close it until the end of the project creation, but I felt that 3 hours was way beyond a normal creation. And now if I try to create another project it will behave in the same way. What should I do to return to normal ?

Accepted answer

permanent link
Doug Ishigaki (6612) | answered Apr 19 '16, 9:54 a.m.
Which sandbox?  You can see which sandbox in the URL.  Copy/paste it here.

Bruno Di Giandomenico selected this answer as the correct answer

Doug Ishigaki commented Apr 19 '16, 10:04 a.m.

BTW, only sandbox04 has Configuration Management activated.

If sandbox04, can you go to  and see if all your projects appear (CCM, RM, QM)?  Sometimes the project creation will show incomplete progress (e.g., 75%) even though it really completed.

Also, can you give me the lifecycle project name for the last incomplete (it it's still incomplete)?

Bruno Di Giandomenico commented Apr 19 '16, 10:12 a.m.

The sandbox is Still there, at 75%, waiting Setting up project area associations...

The project should be named DarkFeys
Thanks. It it can be stopped and / or deleted it would be allright
And when I try the same address, it only asks me if I want to create a new project, therefore I assume the creation did not reach completion

Bruno Di Giandomenico commented Apr 19 '16, 10:13 a.m.

 Thanks for the indication of the sandox with CM enabled.

Bruno Di Giandomenico commented Apr 19 '16, 10:22 a.m.

The project creation worked without a hitch on sandbox 4, thank you very much for the help.

Your answer

Register or to post your answer.