Missing Iterations when customising burndown/burnup charts

Daniel Grant (8●1●3) | asked Jan 22 '15, 5:55 a.m.

Hi Guys,

I have multiple iterations in my project.

When I go to the project dashboard and try to customise either a burndown or burnup report, I can only select from a subset of my iterations.

The list of iterations is missing about half even though the number of total iterations that i can select from (below the list) is accurate.

Has anybody encountered anything like this before? I am running RTC 4.0.6.

Accepted answer

permanent link

Ralph Schoon (62.0k●3●36●43) | answered Jan 22 '15, 7:13 a.m.
FORUM ADMINISTRATOR / FORUM MODERATOR / JAZZ DEVELOPER

Usually this is due to

A lot of the charts require team areas - this is typically visible as team area is a parameter in that case.

Daniel Grant selected this answer as the correct answer

Comments

Daniel Grant commented Jan 22 '15, 7:49 a.m.

Thank for the answer Ralph,

In my case it is iterations without any assigned work items not showing.

I had assumed even empty iterations would be listed and would just load as an empty burndown/burnup chart.