It's all about the answers!

Ask a question

How can I get breakpoints working again in Jetty debugging?


Dustin Walker (282) | asked Nov 05 '19, 12:16 p.m.

 I am following through the extend ability workshop shown here in this link:



I have gone through labs 1 and 2 with no issues. However once I get to lab 3, breakpoints no longer cause the Jetty (OSGi2 Launch) server to suspend action. This behavior happened after I accepted the pending changes in source control. I have verified that breakpoints are still operational in the (Remote Java Application) [RTCExt] Debug Liberty Profile. I have verified that Ctrl+Alt+b (skip breakpoints) is not enabled. Advice and direction on the matter would be greatly appreciated. Thank you!

Accepted answer


permanent link
Dustin Walker (282) | answered Nov 05 '19, 12:28 p.m.

I realized that my issue was I was running the jetty configuration, not debugging the jetty configuration. I hope this helps someone else.

Ralph Schoon selected this answer as the correct answer

Comments
Ralph Schoon commented Nov 05 '19, 3:59 p.m.
FORUM ADMINISTRATOR / FORUM MODERATOR / JAZZ DEVELOPER

Thanks Dustin, you are not alone with this issue. I can assure you. 

Your answer


Register or to post your answer.