It's all about the answers!

Ask a question

Switching to an LDAP registry


Jeff Stratford (7182) | asked Jul 15 '10, 12:58 p.m.
There are 2 places that need to be configured when switch to LDAP, correct?

1) the WAS server needs to be configured first
2) then I need to go and configure everything in RAM

Is this correct?

Thank you.

Jeff

2 answers



permanent link
Jeff Stratford (7182) | answered Jul 15 '10, 1:50 p.m.
On 7/15/2010 12:58 PM, Jeff Stratford wrote:
There are 2 places that need to be configured when switch to LDAP, correct?

1) the WAS server needs to be configured first
2) then I need to go and configure everything in RAM

Is this correct?

Thank you.

Jeff

I'm in. I found an old document that apparently is not out of date.

The only gotcha is that I had to back and run the setup program to
reconfigure the RTC connection,,, again.

Jeff

permanent link
Rich Kulp (3.6k38) | answered Jul 15 '10, 2:38 p.m.
FORUM MODERATOR / JAZZ DEVELOPER
Once you change the WAS LDAP, Server Setup should help you change both
RAM and RTC for you.

Rich

Your answer


Register or to post your answer.