It's all about the answers!

Ask a question

What does "could not select iterations to use in velocity report" mean in RTC 60 quickplanner view?


Sunil Kumar R (1.1k13344) | asked Sep 30 '15, 9:59 a.m.
JAZZ DEVELOPER
On RTC 6.0 (sample project area - based on JKE banking) a message as highlighted below is seen

could not select iterations to use in velocity report

What does it mean?
Steps to arrive at this page:
a. Go to RTC sample project area "JKE Banking"
b. Click "Quick Planner" under "Plans" view.
c. Click on "Velocity Report" twistie and you will see the message..

Here is the snapshot for reference...

Best Regards
Sunil


2 answers



permanent link
Ralph Schoon (63.7k33648) | answered Sep 30 '15, 10:40 a.m.
FORUM ADMINISTRATOR / FORUM MODERATOR / JAZZ DEVELOPER
edited Sep 30 '15, 10:40 a.m.
This, in 99% of the cases means that there is no such data in the data warehouse. E.g. the data collection component or data warehouse is not set up or the data collection jobs did not run, or there are no iterations, or different assumptions about the project set up.

permanent link
Sunil Kumar R (1.1k13344) | answered Oct 05 '15, 5:00 a.m.
JAZZ DEVELOPER
Thank you Ralph, but i tried ruling out datawarehouse, no iteration - so these 2 dont seem to be an issue.
i.e., DW have run succesfully, there are iterations (its on JKE Banking CCM project area).

Anything else we could think of?

Your answer


Register or to post your answer.


Dashboards and work items are no longer publicly available, so some links may be invalid. We now provide similar information through other means. Learn more here.