Jazz Build Queue problems
Hey folks:
I've got a few different build descriptions set up and running on Jazz 0.6M3a. I have one, however, that complains whenever I request a build, saying a request is already in the queue and asking if I'm sure I'd like to request a new build. The new request runs fine whenever I click yes, but looking in the build queue (under Build Engine Activity in the Team Artifacts view) shows no pending build requests. I believe an old (unused) build descriptor with the same name was renamed so that this new one could take it's place, so could that be confusing the system? Regardless of what is causing it, is there a way to clear the build queue completely and start fresh? Thanks so much for your time.
I've got a few different build descriptions set up and running on Jazz 0.6M3a. I have one, however, that complains whenever I request a build, saying a request is already in the queue and asking if I'm sure I'd like to request a new build. The new request runs fine whenever I click yes, but looking in the build queue (under Build Engine Activity in the Team Artifacts view) shows no pending build requests. I believe an old (unused) build descriptor with the same name was renamed so that this new one could take it's place, so could that be confusing the system? Regardless of what is causing it, is there a way to clear the build queue completely and start fresh? Thanks so much for your time.
One answer
A rename of the definition shouldn't cause this problem. But, if the
associated team area was changed on the definition, to be a team in a
different project area that you are no longer connected to, this might
happen.
In Team Artifacts, make sure you are connected to all Project Areas that you
were in the past (click the "Connect to Project Areas" button in the view
toolbar). Then look at the Build Queue for each project area. Notice the
Build Queue is scoped to a project area.
In the Builds view, if you see the pending request, you can cancel it by
right-clicking the request and choosing "Cancel build request".
associated team area was changed on the definition, to be a team in a
different project area that you are no longer connected to, this might
happen.
In Team Artifacts, make sure you are connected to all Project Areas that you
were in the past (click the "Connect to Project Areas" button in the view
toolbar). Then look at the Build Queue for each project area. Notice the
Build Queue is scoped to a project area.
In the Builds view, if you see the pending request, you can cancel it by
right-clicking the request and choosing "Cancel build request".