It's all about the answers!

Ask a question

Team load shows 0 after iteration plan refresh

Mark Miller (41118) | asked Oct 10 '08, 4:27 p.m.
I am running Rational Team Concert (RTC)
Version: 1.0
Build id: I20080618-1642

When I add work items with estimates they show up correctly in the Team load section of Team Central as well as on the Iteration Plan when grouped by Owner with bar set to Load, but if I then press the refresh button on the Iteration plan the Team load bars all go to 0. If I then add another work item that work items estimate will show up in the Team load section, but the other work items entered before the refresh do not. If i press refresh again the loads go back down to 0.

Has anyone else seen this behavior?

One answer

permanent link
Mark Miller (41118) | answered Oct 31 '08, 2:57 p.m.
I was going to submit this as a defect but found that someone else did earlier today it is defect 63740.

Your answer

Register or to post your answer.