It's all about the answers!

Ask a question
QuestionsTagsUsersBadges
Follow this question
Question details

×11,703
×10,750

question asked: Jul 18 '18, 4:14 a.m.
question was seen: 773 times
last updated: Jul 18 '18, 2:00 p.m.

Related questions

FAQ - How this Forum works

RQM with Doors Classic - Reconcile

0
Monika Schäfer (15●2) | asked Jul 18 '18, 4:14 a.m.

Hi, when I reconcile the requirements, changed and removed requirements are not recognized by the tool. Is there any known issue or is reconcile not possible with Doors Classic?

One answer

Most liked answers ↓|Newest answers|Oldest answers

0
permanent link
Mehul Patel (969●5) | answered Jul 18 '18, 5:50 a.m.
FORUM MODERATOR

Monika,


It should work. I would check DWA and RQM integration in such case. 
DWA check: 
 - Are you able to create link to DOORS requirement from RQM? 
 - Are you getting rich-hover for DOORS requirement from RQM? 
 - Do you have ensured DCN commands have run properly on while configuring DWA?
 - Change in DOORS requirement is reflating on DWA? 
 - If yes then I would say DWA is configured properly. 

Could you please share the version of DOORS and RQM you are using?

Regards,
Mehul

Comments
Monika Schäfer commented Jul 18 '18, 7:40 a.m.

Hi Mehul,

  • I can create links from RQM to Doors
  • rich-hover in RQM is possible
  • how can I check if DCN commands have run properly?
  • change in req. is reflecting in in DWA

Version of RQM: 6.0.5 iFix007

Version of Doors: 9.6.1.10

Regards and thanks
Monika

Mehul Patel commented Jul 18 '18, 2:00 p.m.
FORUM MODERATOR

Monika,


It appears like you have configured this integration correctly and reconciliation across given major versions is supported. I would suggest to contact support and log a ticket for further investigation.

Regards,
Mehul

Your answer

Register or to post your answer.