It's all about the answers!

Ask a question

Link is not showing on DNG


Monali Jambhulkar (841639) | asked Jan 15 '18, 1:41 a.m.

 Hello All,


We have added requirement in Test case in "Requirement link " section of the Test case in RQM . Its is visble in RQM .

But when i have open the same req in DNG , and see Link section,. I am not able to see any Test cases in Link section in DNG.

I am expecting if link is present in RQM side , then It should be visible in DNG side also.

Please suggest.

I am using DNG an RQM 6.0.3 ver.

Thanks

One answer



permanent link
Elohim Arranaga (2461) | answered Jan 16 '18, 8:51 a.m.
JAZZ DEVELOPER

 Hi Monali, as you mention the link should be also reflected on DNG side, however if you are using a configuration management enabled project area the links may take a while to be reflected, the time depends on your refresh rate in ldx, normally from 1 to 5 mins but can be manually changed. Now if this is not the case  or if you have given enough time and the link is still not appearing then this could be a product issue, please open up a ticket for support so we can follow up and investigate more thoroughly. 


Comments
Monali Jambhulkar commented Jan 17 '18, 1:15 a.m.

 Thanks alot. 

But I am not using Configuration management enable project area.
Still link is  not visible on DNG side.
This could be Product issue. I will open the ticket for the same.

Thanks

Your answer


Register or to post your answer.


Dashboards and work items are no longer publicly available, so some links may be invalid. We now provide similar information through other means. Learn more here.