Why don't the parameters for shared reports populate on execution?
RQM 4.0.1:
I am in the process of executing shared reports to know the progress of Test Execution and Defects status.
One of the report being "Test Case impacted by Defects", when selecting the parameters, the Test Plan list is empty!!
So ran another report "Execution Status by weight" (to see if the same problem persists), now the Test plan list IS populated.
Is there a reason why the same Test Plan parameter behaves differently for different reports?
Also, none of the reports are fetching any results, even after running the data collection jobs.
Tried to access the reports from Rational Insight, same problem, infact some reports does not detect the Project area!
Any suggestions?
One answer
Hi Radha,
The "Test cases Impacted by Defects" report uses the data warehouse. So the ETL jobs will need to run successfully to load the data into the data warehouse before you see data in the report.
For the other report, "Execution Status by weight" this is a live report and does not use the data warehouse. So it will do a query against your project repository and not the data warehouse.
I hope this helps.
The "Test cases Impacted by Defects" report uses the data warehouse. So the ETL jobs will need to run successfully to load the data into the data warehouse before you see data in the report.
For the other report, "Execution Status by weight" this is a live report and does not use the data warehouse. So it will do a query against your project repository and not the data warehouse.
I hope this helps.
Comments
