It's all about the answers!

Ask a question

Creating life cycle project - what to do with add an artifact container to the lifecycle project.


Ayan Paul (2552230) | asked Mar 03 '13, 11:24 p.m.
i am creating a lifecycle project in 4.0.1
After selecting process template for rm.ccm & qm and clicking on save, it is showing a message
'Click Add... to add an artifact container to the lifecycle project.' what to select for this and why? previously in 4.0 we haven't seen this. Please reply ASAP.

3 answers



permanent link
Rajesh Avanthi (10815137173) | answered Mar 03 '13, 11:40 p.m.
Hi Ayan

On the terminology side we introduced “Lifecycle Project” to refer to the network of linked project areas. These project areas are the containers for all the artifacts that can be linked to each other. In the context of a lifecycle project we therefore call them “Artifact Containers”. This name also emphasizes that artifact containers may be realized differently than by project areas.


Does this answer your question?

permanent link
Ayan Paul (2552230) | answered Mar 03 '13, 11:55 p.m.
actually thru firefox not able to create the project, after saving it gets hanged, but now able to create the same thru IE.

Comments
Rajesh Avanthi commented Mar 04 '13, 1:34 a.m.

What is the version of Firefox used ?
If this is the latest version then please try on lower version of the same and check.


permanent link
Rajat Singh (59833545) | answered Mar 04 '13, 3:08 a.m.
Dear Ayan

The supported browsers for v4.0.1 are as below:

Please make sure you are using either of them.

Best Regards
Rajat

Your answer


Register or to post your answer.