Reset DOORs Module baselines back to 0.0 and maintain links?

I have a program that effectively wants to restart a project using an existing DOORs Project Data base, but wants all the modules to start back at version 0.0. Does anyone know if there is a way to to do this and maintain all links?

I found the following DXL script posted that allows you to perform a baseline and keep the version the same:

Baseline b = suffix("abcde")
Module m = current
ModName_ mn = module m
Baseline bNew = baseline(major b, minor b, suffix b)
create (m, b, "Blah")
load(moduleVersion (mn, bNew), true)

Is there a way to modifiy this script to set the baseline version to 0.0?

Thanks!
KathleenVincent - Wed Nov 09 14:40:18 EST 2011

Re: Reset DOORs Module baselines back to 0.0 and maintain links?
SystemAdmin - Wed Nov 09 17:05:36 EST 2011

Go to the following post and look for a response from me where I describe a method that takes advantage of the Partitions feature of DOORS to effectively create a copy of a project where the baselines in each module are reset back to zero.

https://www.ibm.com/developerworks/forums/thread.jspa?messageID=14220098

Paul Miller
Melbourne, Australia

Re: Reset DOORs Module baselines back to 0.0 and maintain links?
SystemAdmin - Wed Nov 09 17:09:55 EST 2011

SystemAdmin - Wed Nov 09 17:05:36 EST 2011
Go to the following post and look for a response from me where I describe a method that takes advantage of the Partitions feature of DOORS to effectively create a copy of a project where the baselines in each module are reset back to zero.

https://www.ibm.com/developerworks/forums/thread.jspa?messageID=14220098

Paul Miller
Melbourne, Australia

Gee I wish this forum would support editing of posts - I was going to add that as far as I know, DXL cannot be used to do this, the method I described above seems to be the most efficient approach.
Paul Miller
Melbourne, Australia

Re: Reset DOORs Module baselines back to 0.0 and maintain links?
KathleenVincent - Wed Nov 09 17:57:43 EST 2011

SystemAdmin - Wed Nov 09 17:05:36 EST 2011
Go to the following post and look for a response from me where I describe a method that takes advantage of the Partitions feature of DOORS to effectively create a copy of a project where the baselines in each module are reset back to zero.

https://www.ibm.com/developerworks/forums/thread.jspa?messageID=14220098

Paul Miller
Melbourne, Australia

Paul,

Thank you VERY much for sharing this information with me...greatly appreciated!

Kathleen